before you begin with the work,  you should absolutely, which most important safety rules consider   The control is used to switch on and off electrical circuits. It is for example in the exchange circuit (elimination) or in the cross circuit.     This switch has the advantage that with the help of a small lamp in the switch is always to be seen whether the light in the basement, garage, in the 1st floor  is turned on or not.     Operation:   By pressing the switch is a contact from the entrance to the L output 1 or output 2 (depending on the position switch). The terminal point for the outer conductor is on the front page with a red color. The terminal point for the neutral conductor is on the front page with a blue color.       Back:    Output 1       Output 2           Terminal for the outer conductor neutral conductor     Front page:
©2008 Rieplay.com our partners:      engineering   electrical engineering   painting wall Important note! The work with power can be dangerous and should only be professionals! We give tips on just right execution. About Take no liability or the like for damages for improper execution! So if in doubt, always an electric expert advice! Please visit our imprint