before you begin with the work,  you should absolutely, which most important safety rules consider     The series - button is used to send a short-term current impulse, for example, to a stairwell machine or a ring (Gong) .... It is for example in the stairwell or circuit in the electric circuit. A series switch is basically like two normal button, electrically completely separated in one. It will be used where, for example, no place for 2 separate button is available.      Operation:   By pressing the button 1 is a contact from the entrance 1 to output 1.4 When the button is released into contact with output 1.2. So you can make it either as a circuit - or as a breaker circuit - NO.   By pressing the button 2 is a contact from the entrance 2 to output 2.4 When the button is released into contact with output 2.2 So you can make it either as a circuit - or as a breaker circuit - NO.   This "two-button" are electrically separated, so if you are satisfied with the 2 buttons only a circuit switching, you have to input 1 and input 2 with a small wire bridge.   Back:  Output 2.2            Output 2.4                  Input 2                        Input 1              Output 1.2           Output 1.4                      Front page:
©2008 Rieplay.com our partners:      engineering   electrical engineering   painting wall Important note! The work with power can be dangerous and should only be professionals! We give tips on just right execution. About Take no liability or the like for damages for improper execution! So if in doubt, always an electric expert advice! Please visit our imprint