before you begin with the work,  you should absolutely, which most important safety rules consider Fitting sockets         First, the exterior insulation of the cable removed. Check now exposed veins. Their isolation may not be damaged. Moreover, a damaged copper slightly later cancel. Of the inner wires is the isolation to 1 - 1.5 cm with a stripping pliers.    The connection is made through the veins or screw clamps. Mostly, however, to use plug-in which only the wire push in. For outlets with screw, the artery to an eyelet bent (the end points in the direction in which the screw tightened). In principle, isolated from the end always completely disappear in the terminal in order to prevent short circuits.       In sockets The terminals are almost never described. It should be clamped on.     N (blue) Left Head protection (green-yellow) in the middle Phase (black) Right    But it totally does not matter whether you are N or external left or head stuck right in! Left (N)       center (PE)       right (L)      With flexible with fine lines copper filament come wire - end sleeve for use on the fine wires and check problems with a pressing pliers is fixed for a clean (solid) connection.
©2008 Rieplay.com our partners:      engineering   electrical engineering   painting wall Important note! The work with power can be dangerous and should only be professionals! We give tips on just right execution. About Take no liability or the like for damages for improper execution! So if in doubt, always an electric expert advice! Please visit our imprint